Loading traverse for safe lifting and transporting of cable drums. With chain suspension and 2 adjustable steel rope suspensions, suitable for drums acc. table below. Further dimensions are available on short call.

Cable drum quick-lift hooks for safe lifting and transporting cable drums if there is no space to insert a long drum shaft. Not suitable to unwind cable drums. Made of steel galvanized.

Cable drum quick-lift hooks for safe lifting and transporting cable drums if there is no space to insert a long drum shaft. Not suitable to unwind cable drums. Made of steel galvanized.

Cable drum shafts rotating, solid alu with bearings and recessed ends, without clamps.

Cable drum shafts rotating, tubular steel with bearings and recessed ends, without clamps.

Tubular steel drum shafts, rotating with friction bearings, without clamps, for heavy drum weights and wider drums. Shaft length must be 500 mm longer than the drum width. Especially for application with the THD hydraulic jacks. The load capacities are corresponding to the widest possible drum, for reduced width the capacity decreases significantly. Static calculations are available.

Suspension with shackle only for rotating drum shafts for lifting and unwinding cable drums, without cones.

Below mentioned capacity is per pair. Two are required

Locating cone for drum shafts made of cast steel including clamp. With several steps for drum bores according to DIN.

2 pieces need to be ordered

Centring bushes for drum shafts to fit with the drum bore, see table below. Also available in other diameters. Bush length 80 mm

Clamps, new especially reinforced construction, for lateral securing of the cable drum on the axles and shafts, hinged, very tight and secure fit due to all-round surface pressure, galvanised, width 61

Clamp for drum shafts for lateral fixing of the cable drum on drum shafts of steel or alu. Steel coated. Width 50 mm.