Cable drum unwinder for very small drums with one or two flanges. The unwinder can accommodate a wide variety of drums with a bore from 20 mm by combining different cones. Due to its low weight of only 6.4 kg, it is very handy and yet has a high stability. This makes it very safe to use, e.g. for in-house cabling.
For drum D up to 300 mm and drum width up to 220 mm, weight max. 5 kg
Clamping bearings for easy running and small pull-off forces
Cable unwinder for small drums, even with damaged flanged wheels for electric installation works. Tubular steel construction galvanized. Consisting of: basic frame with 2 rubber coated wheels, one drum shaft D 25 mm with 2 cones of polyamide for hole diameter 25-80 mm.
Collapsible for easy transportation to the site.
Easy movable with the drum through big rubber coated wheels.
For drum-D to 800 and drum widths to 530, drum weight max. 200 kg
As accessory steel tube drum shaft D 50, ball bearings, 2 clamps, for cones see table below.
Cable drum trailer with straight or height adjustable draw bar and overrun brake for speeds up to 80 km/h. For loading the support arms are swung down and then raised picking up the drum by a single hand winch. Rotatable aluminium shaft as accessory, see below
Payload without accessories. If accessories are mounted like hydr. drum drives etc. the payload reduces according to their weights.
Types G - with straight draw bar can only be equipped with ball coupling
Types H - with adjustable draw bar equipped with eye coupling, ball coupling as accessory
Suitable for one-man operation
Complete trailer hot galvanized
Rotating alu shafts as accessory, please order shaft clamps separately.
Drum band brake as accessory, see below.
Position lighting at the front of the cable drum trailer
Surcharge for rotating drum shafts. The standard trailers listed above are delivered without shaft as standard. With rotating shafts cable drums unwind much easier, they are necessary if the trailer is equipped with a drum drive or a drum disc brake.
Cable drum band brake for KVS 1000-2000/80 without shaft, to screw on rotating alu shaft. This band brake avoids uncontrolled unwinding of the cable drum. Mostly used for unwinding overhead lines.
Drum drive one side for cable trailers KVS 1000-2000/80, but not suitable for all types, see table below. Hydraulic or pneumatic, without hoses and power packs.
Hydraulic power pack for cable drum drive, with petrol- or Diesel engine equipped with rapid hose couplings. Oil presser 160 bar, tank 10 Litre, oil flow 12 l/min. l/min.
The hydraulic power pack must not be mounted on drawing bar of the trailer, the hitch load would be to high.
For control of the winding speed please order below mentioned hydraulic hose combination
