1 | Cable trailer adjustable drawbar
Cable drum trailer with height adjustable draw bar with eye coupling and overrun brake for speeds up to 80 km/h. Drums are vertically lifted for transport by two hydraulic jacks operated by y central hand pump or by motorized hydraulic used as an accessory. Rigid tubular steel shaft D 76 mm. Rotating as accessory. Further accessory see below. Techn. Details see below.
 
Payload without accessories. If accessories are mounted like hydr. drum drives etc. the payload reduces according to their weights.
Trailers with height adjustable draw bar are equipped with eye coupling, ball coupling as accessory.
Through stub axles the trailer is open to the rear for receiving the cable drum.
Big ground clearance through long lift hydraulic jacks.
According to guide line 70/221 EWG the trailers have to be equipped with rear protection gates
Special painting as accessory, Code 350.980, KSL
Cable-drum-trailer,342304
CodeTypePayload Total Drum-D Hitch Int-/Extern kg
342304 KVH 2.6/80A2600 kg 3500 kg 1400-3000 150 kg 1720/540 860,00
2 | Small drum suspension
Small drum suspension for drums below D 1300-800 mm, for KVH 2,6/80A

Cable-drum-trailer,350940
CodeTypeSuitable for Drum-D Trailer width Shaft-D kg
350940 KVZ 180KVH 2.6/80 A 800-1300 mm 2550 mm 76 mm 68,00
3 | Drum support
Additional support in front of the trailer for winding and unwinding drums smaller than D 1400-800 mm by the hydraulic drum drives on KVH-trailers. One set exists of one right-hand and one left-hand support. For loading these drums a lifting equipment is necessary.
 
Non additional drum shaft is necessary, the standard shaft of the trailer can be used.
,350955
CodeTypeSuitable for Drum-D Trailer width kg
350955 TAV 080KVH 2.6-9,0 800-1500 mm unlimited 17,00
4 | Rear protection gate
Rear protection gate, for Cable trailers KVH 2.6/80 A
 
The need of a rear protection is subject to national regulations. Independent of this, the rear protection offers a higher safety in the road traffic.
Cable-drum-trailer,349836
CodeTypeSuitable for Trailer ext. width kg
349836 KUF 260KVH 2.6/80 2540 mm 40,00
5 | Position lights
Position lights 12 volt, in front of the trailers KVS 1000-2000 G + H, according to the law of some countries

Ballcoupling,349550
CodeTypeSuitable for kg
349550 KPL 12KVS 1000-2000 G + H 3,00
6 | Ball coupling
Ball coupling with screws, changeable against height adjustable drawbar eye coupling for trailers with overrun brake.

Cable-drum-trailer,349190
CodeTypeSuitable for Total weight kg
349190 PK 25KVH 2.6/80 A 3500 kg 2,90
7 | Rotating steel drum shafts
Surcharge for rotating drum shafts. All a.m. trailers are fitted with rigid tubular steel drum shafts. With rotating shafts cable drums unwind much easier, they are necessary if the trailer is equipped with a drum drive or a drum disc brake.
The cones are with stages for all drum holes from diam. 80-140 mm.
If no drum disc brake is necessary the use of below mentioned light alu drum shaft is recommended.
Trommelachsen,Trommelwellen,350790
CodeTypeSuitable for D/length kg
350790 APR 690KVH 2.6-4.6/FZB 2550 76/10/1888 mm 44,00
8 | Rotating alu drum shafts
Surcharge for rotating aluminium drum shaft. Instead of the steel shafts this aluminium drum shaft with mounted rotating bearingscan be used. It is much lighter than the steel shaft. It is also suitable for all hydraulic drum drives, but not for the drum disc brake.

Trommelachsen,Trommelwellen,35079075
CodeTypeSuitable for D/length kg
35079075 APR 755KVH 2.6-5.3/FZB 2550 75/1888 mm 34,00
9 | Cable drum disc brake
Cable drum disc brake with drum fork for controlled unwinding of cable or line drums. Hand mechanical setting of the braking force. To use it with KVH-types code 350.790 APR 690 is necessary.

Cable-drum-trailer,350860
CodeTypeOperation Braking At the cable kg
350860 STB 400mechanic 3200 Nm approx. 4,0 kN 46,00
10 | Cable drum drive for KVH 2.6/80A
Cable drum drive for cable drum trailer KVH 2.6/80, driven by an external hydraulic drive e.g. from the lorry, or by a separate petrol-hydraulic power pack, mount- or dismountable on the trailer, see below code 351.330, THF 203. (The hydr. power pack may not be mounted permanently on the trailer because the hitch load would be to high, so during transportation it has to be dismounted.)

Cable-drum-trailer,351320
Cable-drum-trailer,351324
CodeTypeDrive Hydraulic Pull force kN m/min. kg
351320 TZH 206on 1 flange external hydraulic 2,0 0-40 61,00
351324 TZH 202on 2 flanges external hydraulic 5,0 0-40 120,00
11 | Hydraulic power pack for drum drives
Hydraulic power pack for cable drum drives with petrol engine with hoses equipped with rapid hose couplings.

Tank 10 Litre, oil flow 12 l/min.
Cable-drum-trailer,351330
CodeTypeSuitable for Hydr. Aggr. Pressure L/W/H mm kg
351330 THF 203drum drives petrol 9,6 kW 160 bar 854/457/507 74,00
12 | Cable trailer adjustable drawbar
Cable drum trailer with height adjustable draw bar with eye coupling and overrun brake. Tandem axle for speeds up to 80 km/h. Drums are lifted for transport by two swung arms hydraulic operated by motorized hydraulic included drum drive as an accessory. Rigid tubular steel shaft D 76 mm. Rotating as accessory. Further accessory see below.
 
Payload without accessories. If accessories are mounted like hydr. drum drives etc. the payload reduces according to their weights.
Very robust welded construction, complete hot galvanized.
Through tandem axle even distribution of the total weight on each wheel.
Drum lifting arms operated by double action hydraulic jacks.
Cable-drum-trailer,342310
CodeTypePayload Total Drum-D Hitch Int-/Extern kg
342310 KVT 2,7/80A2700 kg 3500 kg 1000-2800 150 kg 1720/540 920,00
13 | Rear protection gate
Rear protection gate, for Cable trailers KVT 2.6/80 A, plug-in device
 
The need of a rear protection is subject to national regulations. Independent of this, the rear protection offers a higher safety in the road traffic.
Cable-drum-trailer,349838
CodeTypeSuitable for Trailer ext. width kg
349838 KUF 270KVT 2.7/80 2540 mm 40,00
14 | Ball coupling
Ball coupling with screws, changeable against height adjustable drawbar eye coupling for trailers with overrun brake.

Cable-drum-trailer,349110
CodeTypeSuitable for Total weight kg
349110 PK 35KVT 2,7/80A 3500 kg 2,50
15 | Rotating drum shafts
Surcharge for rotating drum shafts. All a.m. trailers are fitted with rigid tubular steel drum shafts. With rotating shafts cable drums unwind much easier, they are necessary if the trailer is equipped with a drum drive or a drum disc brake.

Rotating-drum-shafts,350785
CodeTypeSuitable for D/length kg
350785 APR 2005KVT 2,7/80 70/2005 mm 44,00
16 | Drum and jack drive
Cable drum drive both sides, with drive of the hydraulic jacks, with petrol-engine on the trailer for cable trailer KVT 2,7/80. Type TH 400 is only for motor-hydraulic loading and unloading of the drum.

Drum-jack-drive,drum-drive,351560
Drum-jack-drive,drum-drive,351570
CodeTypeDrive Engine Pull force m/min. kg
351560 TVB 400hydraulic Petrol 4 kW 3 kN 0-36 215,00
351570 TH 400hydraulic Petrol 4 kW only for drum jacks - 30,00
17 | Protection for petrol engine
Protection of metal sheet for petrol engine of cable drum drives, folding and lockable, without padlock.

Protection for petrol engine,351598
CodeTypeSuitable for kg
351598 BVB 400TVB 400 petrol engine 10,00
18 | Trailer for subducts and cable drums
Trailer for subduct drums. Also prepared for transporting cable drums. With height adjustable draw bar with eye coupling and overrun brake. Tandem axle for speeds up to 80 km/h. Subduct drums or cable drums are lifted for transport by two swung arms hydraulic operated by motorized hydraulic included drum drive as an accessory. For transporting and unwinding of subducts the suspension ZGH 7/120 for up to 7 subduct drums is necessary. See accessory below.
 
Payload without accessories. If accessories are mounted like hydr. drum drives etc. the payload reduces according to their weights.
Very robust welded construction, complete hot galvanized.
Through tandem axle even distribution of the total weight on each wheel.
Drum lifting arms operated by double action hydraulic jacks.
Attention: please see mobile drum unwinding stand code 344.100 TRG 8120
Cable-drum-trailer,342310
CodeTypePayload Total Drum-D Hitch Int-/Extern kg
342310 KVT 2,7/80A2700 kg 3500 kg 1000-2800 150 kg 1720/540 920,00
19 | Suspension for subduct drums
Suspension for subduct drums. Incl. drum shafts, distance bushes and clamps.

Attention: please see mobile drum unwinding stand code 344.100 TRG 8120
Cable-drum-trailer,342317
CodeTypeDrum Drum-D mm kg/drum kg
342317 ZGH 7/120up to 7 pcs. 1200, width 380 appr. 100 kg 154,92